Peraturan Menteri Perhubungan Nomor 63 Tahun 2017
- Nomor
- 63
- Tahun
- 2017
- Ditetapkan
- Fase
- Berlaku
- Pasal terindeks
- 2
menetapkan Peraturan Menteri Perhubungan tentang Perubahan Kesepuluh atas Keputusan Menteri Perhubungan Nomor KM 18 Tahun 2002 tentang Persyaratan-Persyaratan Sertifikasi dan Operasi Bagi Perusahaan Angkutan Udara Niaga Untuk Penerbangan Komuter Dan Charter; Mengingat : 1. Undang-Undang Republik Indonesia Nomor 1 Tahun 2009 tentang Penerbangan (Lembaran Negara Republik Indonesia Tahun 2009 Nomor 1, Tambahan Lembaran Negara Republik Indonesia Nomor 4956);
MEMUTUSKAN Menetapkan : PERATURAN MENTERI PERHUBUNGAN TENTANG PERUBAHAN KESEPULUH ATAS KEPUTUSAN MENTERI PERHUBUNGAN NOMOR KM 18 TAHUN 2002 TENTANG PERSYARATAN-PERSYARATAN SERTIFIKASI DAN OPERASI BAGI PERUSAHAAN ANGKUTAN UDARA NIAGA UNTUK PENERBANGAN KOMUTER DAN CHARTER. Pasall Keputusan Menteri Perhubungan Nomor KM 18 Tahun 2002 tentang Persyaratan Persyaratan Sertifikasi dan Operasi Bagi Perusahaan Angkutan Udara untuk Penerbangan Komuter dan Charter yang telah beberapa kali diubah dengan Peraturan Menteri:
diubah sebagai berikut:
135.1 Reserved
135.11 Requirements of Single Engine Operation (a) Unless otherwise authorized by the Director, no certificate holder shall conduct an air transportation service under this part in a single engine aircraft except:
(b) A certificate holder may apply to the Director to operate a single engine airplane under VFR and IFR conditions where in addition to the requirements laid down in Subsections (a) and (b) of this section, the following conditions are met:
Note: Power loss in this context is defined as any loss ofpower, the cause of which may be traced to faulty engine or engine component design or installation, including design or installation of thefuel ancillary or engine control systems, (ii) The operator shall be responsible for engine trend monitoring. (Hi) To minimize the probability of in-flight engine failure, the engine shall be equipped with: (A) an ignition system that activates automatically, or is capable of being operated manually, for take-off and landing, and during flight, in visible moisture; (B) a magnetic particle detection or equivalent system that monitors the engine, accessories gearbox, and reduction gearbox, and which includes a flight deck caution indication; and (iv) an emergency engine power control device that permits continuing operation of the engine through a sufficient power range to safely complete the flight in the event of any reasonably probable failure of the fuel control unit.
(i) two separate electrical generating systems, each one capable of supplying all probable combinations of continuous in-flight electrical loads for instruments, equipment and systems required at night and/or in IMC; (ii) a radio altimeter; (Hi) an emergency electrical supply system of sufficient capacity and endurance, following loss of all generated power, to as a minimum: (A) maintain the operation of all essential flight instruments, communication and navigation systems during a descent from the maximum certificated altitude in a glide configuration to the completion of a landing; (B) lower the flaps and landing gear, if applicable; (C) provide power to one pitot heater, which must serve an air speed indicator clearly visible to the pilot; (D) provide for operation of the landing light specified in point (x)paragraph (b)(2) of this section; (E) provide for one engine restart, if applicable; and (F) provide for the operation of the radio altimeter; (iv) two attitude indicators, powered from independent sources; (v) a means to provide for at least one attempt at engine re-start; (vi) airborne weather radar; (vii) a certified area navigation system capable of being programmed with the positions of aerodromes and safe forced landing areas, and providing instantly available track and distance information to those locations; (viii) for passenger operations, passenger seats and mounts which meet dynamically-tested performance standards and which are fitted with a shoulder harness or a safety belt with a diagonal shoulder strap for each passenger seat; (be) in pressurized airplanes, sufficient supplemental oxygen for all occupants for descent following engine failure at the maximum glide performance from the maximum certificated altitude to an altitude at which supplemental oxygen is no longer required; (x) a landing light that is independent of the landing gear and is capable of adequately illuminating the touchdown area in a night forced landing; and (xi) an engine fire warning system.
(ii) The DGCA shall review the safety data and monitor the reliability information so as to be able to take any actions necessary to ensure that the intended safety level is achieved. The DGCA will notify major events or trends of particular concern to the appropriate Type Certificate Holder and the State ofDesign.
(A) the nature of the terrain to be overflown, including the potential for carrying out a safe forced landing in the event of an engine failure or major malfunction; (B) weather information, including seasonal and other adverse meteorological influences that may affect the flight; and (C) other criteria and limitations as specified by the DGCA. (ii) An operator shall identify aerodromes or safe forced landing areas available for use in the event of engine failure, and the position of these shall be programmed into the area navigation system.
(ii) all flights operated under the instrument flight rule shall be operated with a minimumflight crew of 2 pilots, who hold a valid commercial or higher pilot licence and have a valid instrument rating, except a SIC is not required if: (A) each aircraft is equipped with a serviceable three axis autopilot, (B) each aircraft is equipped with a headset and boom mike and, a transmit button that is affixed to the control wheel, (C) each aircraft is equipped with a control wheel mounted, approach chart holder with a means of proper illumination, (D) the flight is not operated above flight level 250, (E) the pilot-in-command has successfully completed a single pilot instrument flight check on that aircraft type, (F) the pilot has acquired not less than, 75 hours of instrumentfiight experience as pilot-in-command of which not less than 50 hours must be actual instrument time in an aircraft, and is otherwise qualified in accordance with this Part, and (G) the certificate holder's operational control system is certified for the conduct oflFRflight.
SUBPART D RESERVED
135.27 Contents of the Operations Specifications (a) Each Operations Specification is an attachment to the Air Operator Certificate and addresses at least the following standard operational and maintenance areas;
(b) Operations Specifications shall be supported by appropriate detailed documents, which contain authorization, conditions, and limitations.
135.39 Sources of Aeronautical Products (a) A certificate holder under this part must have the system to obtain the aeronautical products from:
(b) A certificate holder under this part must ensure that the source of aeronautical products has the organization, facilities, equipment and the personnel necessary to comply with the policies, responsibilities, methods and procedures established in his product quality control system;
135.41 Leasing of Aircraft (a) Wet Lease
(i) applicable crewmembers; (ii) operational control; and (Hi) the maintenance and servicing of that aircraft.
(i) The names of the parties to the agreement and the duration thereof (ii) The nationality and registration numbers marks of each aircraft involved in the agreement (Hi) The type of operation (e.g. scheduled, passenger, etc) (iv) The areas of operation (v) The regulation of the CASRs applicable to the operation
(i) Crewmembers and training (ii) Airworthiness and performance of maintenance (Hi) Dispatch (iv) Servicing the aircraft (v) Scheduling (vi) Any other factor the Director considers relevant.
(b) Dry Lease
(i) the aircraft type, model and serial number; (ii) the name and address of the registered owner; (Hi) State of Registry, nationality and registration marks; (iv) certificate ofairworthiness and statement from the registered owner that the aircraft fully complies with the airworthiness requirements of the State of Registry; (v) name, address and signature oflessee or person responsible for operational control of the aircraft under the lease agreement, including a statement that such individual and the parties to the lease agreement fully understand their respective responsibilities under the applicable regulations; (vi) copy of the lease agreement or description of lease provisions; (vii) duration of the lease; and (viii) areas of operation.
(i) flight crew member licensing and training; (ii) cabin crew member training; (Hi) airworthiness of the aircraft and the performance of maintenance; (iv) operational control, including dispatch and flight following; (v) scheduling offlight crew and cabin crew members; and (vi) signing the maintenance release.
(i) names of the parties to the lease agreement and the duration thereof; (ii) nationality and registration marks of each aircraft involved in the agreement; (in) type of aircraft to be used; (iv) areas of operation; and (v) regulations applicable to the operation, (c) Damp Lease Damp Lease is a wet-leased aircraft that includes a cockpit crew but not cabin attendants, generally understood to be a wet lease of an aircraft where the aircraft is operated under the AOC of the lessor, with theflight crew and possibly part of the cabin crew being provided by the lessor. Part or all of the cabin crew is provided by the lessee. The lessee's cabin crew members will need to receive additional training, under the approved training programme of the lessor, with respect to their emergency duties on the particular aircraft. In addition, they may have no knowledge of the requirements of the lessor's State of the Operator with respect to flight and duty time limitations and the provision of rest periods, and to the performance of their duties and responsibilities aboard the wet leased aircraft.
135.367 Maintenance Program. (a) Each certificate holder shall have an maintenance program for each aircraft type including foreign registered aircraft, approved by the DGCA, or state of registry, containing the following:
(b) Maintenance tasks and intervals, that have been specified as mandatory in approval of the type design shall be identified as such. (c) Maintenance program required by this section shall be developed by considering the human factor principles. (d) Copies of all amendments to the maintenance program shall be furnished promptly to all organizations orpersons to whom the maintenance program has been issued.
135.471 Validity Periods for Proficiency and Competency (a) No certificate holder shall assign a person to act and no person shall act, as:
on any type of aircraft unless, in addition to completing the annual recurrent training required by this subsection, that person has successfully completed a Pilot Proficiency Check, (PPQ, Pilot Competency Check, (PCC) or Competency Check, (CC), the validity period of which has not expired. Validity periods for a PPC, PCC, or CC, are as prescribed herein:
(i) for a PIC, the first day of the seventh (7) month following the month the PPC was taken; and (ii) for a SIC, the first day of the thirteenth (13) month following the month in which the PPC was taken.
(i) for a PIC, the first day of the thirteenth (13) month following the month the PPC was taken, and (ii) for a SIC, the first day of the twenty fifth (25) month following the month in which the PPC was taken.
(b) An approved company check pilot who has been delegated the authority to perform flight checks on that aircraft type, or a DGCA inspector shall conduct any pilot proficiency check required by this Subpart. The Director or a person acceptable to him/her shall conduct all other checks required by this Subpart. A certificate holder shall submit to the Director for approval, a list of proposed examiners, including their qualifications relevant to their position as examiners. (c) For the purposes of completing any check required by this subpart, where an aircraft type simulator has been approved for training;
(d) Where any flight simulator, or other training device approved for training and checking, does not have all the training and checking credits needed to complete the entire check, the portions of such check not approved to be completed in a simulator, must be carried out in that type of aircraft, as appropriate. (e) Where a pilot proficiency check, a competency check or annual training is renewed within the last 60 days of its validity period, such check or training is deemed to have taken place on the last day of the validity period. (f) The Director may extend the validity period of a pilot proficiency check, a competency check or annual training by up to 60 days where the Director is of the opinion that aviation safety is not likely to be affected. (g) Where the validity period of a pilot proficiency check, a competency check or annual training has been expired for 24 months or more, the person shall requalify by meeting all initial training requirements relating to that aircraft. Pasal II Peraturan Menteri ini mulai berlaku pada tanggal diundangkan. Agar setiap orang mengetahuinya, memerintahkan pengundangan Peraturan Menteri ini dengan penempatannya dalam Berita Negara Republik Indonesia. Ditetapkan di Jakarta pada tanggal 4 Agustus 2017 MENTERI PERHUBUNGAN ttd BUDI KARYA SUMADI Diundangkan di Jakarta pada tanggal 8 Agustus 2017 DIREKTUR JENDERAL PERATURAN PERUNDANG-UNDANGAN KEMENTERIAN HUKUM DAN HAK ASASI MANUSIA ttd WIDODO EKATJAHJANA BERITA NEGARA REPUBLIK INDONESIA TAHUN 2017 NOMOR 1099 i dengan aslinya BIR© HUKUM RI RAHAYU ama Muda (IV/c) 620 198903 2 010
Membuka PDF…